Autotene Asfaltico EP is used for cold-state waterproofing of bridges and car park surfaces to be paved with hot bitumen or ashphalt.
- Adheres uniformly on its own, hence sealing mistakes are prevented
- Quicker and cheaper laying, saves gas and saves on gas bottle transport
- Can be used both under bituminous conglomerate and under melted asphalt
The bitumen polymer membranes are thermoplastic products and during the summer they soften and it must be remembered that the surfaces of the membrane spread with the self-heat-adhesive mix show strong adhesive properties and that the silicone coated film must be removed only when the correct positioning of the sheet has been determined. At low temperatures the membranes harden and the adhesive properties decrease, but by heating the adhesive face with a %a0%93soft flame, the adhesive strength is reactivated straight away. The air temperature during laying must not be less than 10%94%b0C but attention must be paid so that condensation is not formed on the laying surface, which could be at a lower temperature than that of the air. If the problem is only slight it may be resolved by heating up the laying surface with a torch, whereas in the case of rain or fog or very damp situations, application must be suspended. For total adhesion laying using Autotene Asfaltico EP there is always a potential risk of bubbles forming due to the humidity contained in the cement laying surface, hence it is recommended to lay the waterproof covering as soon as possible.
Compliances and Accreditations
Systems & Installation
Primer: Emer-Proof Self Adhesive Primer
1st layer: Autotene Asfaltico EP
No compatible products found
Projects & Installers
No example projects listed
Index Autotene Asfaltico EPSelf-Heat-Adhesive Bitumen Membrane for use Under Hot Pour Asphalt